20
COLD AIR BLOW BUTTON
The pulsed cold air blow (A) is used to fix
the style without drying the hair.
Pressing it, with the device on, the hot air
cools and gives a better hold to the fold.
As soon as the cold air shot button (A) is
released, the appliance again creates a
flow of hot air corresponding to the pre-
viously selected level.
SECURITY SYSTEM
The appliance is equipped with an anti-
overheating device. In the event of overhe-
ating, heating is stopped and only cold air
is blown out. After cooling, the heating
automatically switches on again with the
emission of hot air again.
Always make sure that the air intakes (D)
and the air outlet (H) are not obstructed
and keep them clean of dust and hair.
CLEANING
ATTENTION: Before cleaning, turn off
the appliance and disconnect the plug
from the socket.
Cleaning appliance and accessories
Clean the hairdryer and accessories (F and
G) if necessary with a soft, damp cloth. Do
not use solvents or aggressive or abrasive
detergents. Otherwise you risk damaging
the surfaces.
Never immerse the device in water or
other liquid substances.
Regularly check the suction sockets of the
appliance and remove dust and accumu-
lated hair.
Cleaning the suction filter
To clean, proceed as follows:
remove the filter holder (L) with the filter
(M) by inserting a coin (P) into the slot on
the edge and rotating it to detach it from
the body of the appliance (Fig.2).
Clean the filter holder (L) and the filter (M)
with a soft, damp cloth or with a soft bri-
stle brush. It is also possible to wash the
filter, using only water without adding any
detergent. Allow to dry thoroughly and
once perfectly dry, refit the filter holder (L)
with the pressure filter (M) on the applian-
ce body.
Never operate the hairdryer without the
filter (M) correctly mounted, the hair
can be sucked into the appliance, dama-
ging it..
Note: the more dust is present in the envi-
ronment where the hairdryer is used, the
greater the frequency with which the filter
holder (L) with the filter (M) must be cle-
aned.
Before using the appliance again, make
sure that all wet cleaned parts are com-
pletely dry.
STORAGE
If the hairdryer is not used, unplug it from
the power socket and store the device in a
dry and dust-protected place.
N.B.: never wrap the network cable
around the appliance, but roll it loosely
on itself without bending it.
L
M
P
Fig.2