14
COMPONENTS:
A. Protective cover
B. Head with abrasive roll
C. Release button
D. 0/1button
E. Battery positioning
F. Batteries
G. Battery container
H. Opening/closure cover
I. Spare abrasive roll head
L. Brush for cleaning
BATTERY INSTALLATION
Remove the battery container (G) turning
it 90 degrees to the left of the covere pla-
stic parts of the product are not covered
by the warranty.
(G) until you hear a click and then pull
downwards.
In the battery container, insert 2 AA (F)
batteries, following the battery positio-
ning + e - (E). Once the batteries are inser-
ted, move the battery container closer and
close turning the opening/closure cover
90° to the right.
Note: Replace the two batteries at the
same time. Do not mix old batteries with
new ones or with other types of batteries.
Pay attention to insert the batteries with
the correct polarity.
If liquid leaks from the batteries which co-
mes in contact with your eyes, wash
which could derive from inadequate di-
sposai of the product. For more detailed
information on recycling of this product,
contact your municipality office, the local
waste disposai service or the shop where
you bought the product.
them immediately with plenty of water and
contact your doctor.
If the battery liquid comes in contact with
your skin or with clothing, wash immedia-
tely with plenty of running water.
Immediately replace the batteries as soon
as they are used up with new ones. Repla-
ce the batteries simultaneously.
Remove the batteries if you do NOT intend
using the appliance for a period of three
or more months. Do not use new and old
batteries simultaneously.
ATTENTION:
This product was designed to smoothen
and soften hard skin on feet and heels. Do
not use this device in any other part of the
body.
Do not use on broken skin.
ASSEMBLY AND OPERATION
To operate the Pedicure you need to insert
the rotating roll head (B) on it, ensuring
the appliance is off before inserting it.
Press the appliance and push the side rele-
ase button (C) inwards.
Keep the button pressed and insert the ro-
tating roller head until you hear a click,
once inserted release the button. Pull the
I/O (D) button up and the corn remover
starts to work, rotating the rotating roller
head roll (B) on itself.
Move the corn remover back and forth on
the part without stopping for more than
2 or 3 seconds on the same point. Do not
press hard, but delicately on the desired
zone.
Stop and check if the desired softness was
achieved.
On the contrary, pass the corn remover in
the area for 2 or 3 seconds and then check
again.
HOW TO INSTALL THE HEAD WITH SPARE
ABRASIVE ROLL
Every now and then you need to replace
the abrasive roll to obtain satisfactory re-
sults. The longevity of the heads varies