A 700 Maintenance Procedure
- 3 -
11. With the small screwdriver, screw clockwise the inner fine adjustment screw
to remove it from the adjustment shaft.
12. Remove the P/N 01.050.126 o-ring from this fine adjustment screw with the
o ring extractor.
13. Remove the balance chamber and the spring from the inlet tube.
14. With great care push the poppet assembly out of the barrel through the
adjustable orifice, with the small screwdriver.
15. With the o-ring extractor remove the 2 o-rings P/N 01.050.363 from the
poppet shaft. Remove also the seat P/N 11.250.221.
16. With the universal tool unscrew the adjustable orifice and push it carefully
out with the wooden chop stick from the hose side.
17. Remove the o-ring from the orifice with the extractor tool.
18. It is not necessary to remove the lever from the inlet tube for cleaning. If
necessary, spread the lever legs carefully and remove one lever tab before
the other to minimise the risk of distorting the lever.
19. It is not necessary to remove the flow reducer from the inlet tube.
20. Inspect the antifriction insert on the inlet tube to detect any wear on the 2
small square holes. It is not necessary to remove this inset.
21. To remove the exhaust tee using no tools.
22.
It is not necessary to remove the exhaust valve unless it needs
replacing.
Pull on the exhaust valve to remove it from the housing.
PARTS CLEANING
WARNING: Refer to parts cleaning procedure.
ASSEMBLY
1. After careful inspection of the cleaned parts and the static o rings that do
not need to be changed, prepare all the parts that need to be changed at
every annual service.
a. P/N 11.250.221 the seat
b. P/N 01.050.363 the 2 poppet o rings
c. P/N 01.050.132 the interstage pressure hose o ring
d. P/N 01.050.293 the adjustment screw o ring
e. P/N 01.006.719 the decal
Or P/N 11.650.045, the annual repair kit.
