OPTIONAL PARTS
3-10
TC-16002-rev.1
5
After attaching the connecting cable to each terminal, run
it out to the false ceiling or outside of the unit.
Connect it to the IR receiver kit.
Refer to the “Installation and Maintenance Manual” of
the indoor unit for indoor unit wiring instructions. When
running the connecting cable, run it to the installation
position of the IR receiver kit through the top of the
mounting plate for the indoor unit. After running the
connecting cable, take the distance (from 3-15/16 to
7-7/8 inch (from 100mm to 200mm) from the indoor unit
undersurface to the connecting cable as shown in the
figure at the right.
After running the connecting cable, clamp the extra
length of the connecting cable using the plastic band and
store it inside the ceiling.
3-15/16 to 7-7/8 inc
h
(100~200mm)
Mounting Plate
Relay Connector
Indoor Unit
Wiring Connection
4
Connect the accessory connecting cable to the terminal block.
Open the electrical box cover of the indoor unit.
Attach the connecting cable to terminals A and B in the
electrical box. (There is no polarity with terminals A and B.)
6
Attach the decorative panel.
Refer to the installation manual for the decorative panel.
Terminal Block for
Controller
Connecting
Cable
Mark Band “B”
Mark Band “A”
(1) Take the connecting cable out from the corner pocket of the decorative panel. Connect the wiring for
the IR receiver kit to the relay connector as shown below.
After connecting, cover the relay connector connection with the wiring cover, and attach the wiring
cover with the plastic bands.
7
After the installation work for the decorative panel is completed, attach the IR receiver kit.
Corner Pocket
Decorative Panel
Connecting Cable
IR Receiver Kit
Plastic Band
Wiring Cover
Plastic Band
Relay
Connector