background image

Published in U.S.A.

www.johnsoncontrols.com

M9300 Series Switch Kits Installation Guide

 Johnson Controls® are registered trademarks of Johnson Controls.

All other marks herein are the marks of their respective owners. © 2019 Johnson Controls.

Building Technologies & Solutions

507 E. Michigan Street, Milwaukee, WI  53202

6

 

European Single Point of Contact:

NA/SA Single Point of Contact:

APAC Single Point of Contact:

JOHNSON CONTROLS

WESTENDHOF 3

45143 ESSEN

GERMANY

JOHNSON CONTROLS

507 E MICHIGAN ST

MILWAUKEE WI 53202

USA

JOHNSON CONTROLS

C/O CONTROLS PRODUCT MANAGEMENT

NO. 22 BLOCK D NEW DISTRICT

WUXI JIANGSU PROVINCE 214142

CHINA

Technical specifications

M9300 Series Switch Kits

Product Description

M9300-1 Switch Kit 

with one single-pole,

double-throw (SPDT) switch

M9300-2 Switch Kit

 with two SPDT

switches

Switch Rating

3 (0.5) A, 240 VAC

Electrical Connection

55 in. (1.4 m) halogen-free cable with
three 18 AWG (0.82 mm

2

) conductors and

1/4 in. (6 mm) ferrule ends

55 in. (1.4 m) halogen-free cable with
six 18 AWG (0.82 mm

2

) conductors and

1/4 in. (6 mm) ferrule ends

Ambient Conditions

Operating: 

-22°F to 140°F (-30°C to 60°C), 95% RH, noncondensing

Storage: 

-40°F to 185°F (-40°C to 85°C), 95% RH, noncondensing

Enclosure

NEMA 5/IP54

Compliance

United States:

UL Listed, CCN XAPX, File E27734; to UL 60730-1: Automatic Electrical Controls for Household 

and Similar Use, Part 1; and UL 60730-2-14: Part 2, Particular Requirements for Electric Actuators. 

Plenum Rated (UL 2043). Suitable for use in Other Environmental Air Space (Plenum) in 

accordance with section 300.22 (c) of the National Electrical Code.

Canada:

UL Listed, CCN XAPX7, File E27734; to CAN/CSA E60730-1:02: Automatic Electrical Controls for 

Household and Similar Use, Part 1; and CAN/CSA-E60730-2-14, Particular Requirements for 

Electric Actuators.

Europe:

CE Mark—Johnson Controls declares that this product is in compliance with the essential 

requirements and other relevant provisions of the Low Voltage Directive.
IEC 60730-1: Automatic Electrical Controls for Household and Similar Use, Part 1: General 

Requirements and IEC 60730-2-14, Automatic Electrical Controls for Household and Similar Use; 

Part 2—Particular Requirements for Electric Actuators

Australia and New Zealand:

 RCM Mark, Australia/NZ Emissions Compliant

The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these 
specifications, consult the local Johnson Controls office. Johnson Controls shall not be liable for damages resulting from misapplication or 
misuse of its products.

Product warranty

This product is covered by a limited warranty, details of which can be found at
 

www.johnsoncontrols.com/buildingswarranty

.

Summary of Contents for M9300 Series







Reviews: