Removing a mounting base installed with double-sided adhesive foam tape
To remove or relocate a sensor mounted with double-sided adhesive foam tape:
1. Remove the sensor housing from its mounting base (Figure 2).
2. Remove the mounting base from the mounting surface by carefully twisting the base off of the
surface.
3. Remove the adhesive foam tape from the mounting base and clean the mounting base to
remove any leftover adhesive.
Note:
New double-sided adhesive foam tape is required to remount the base on the
surface; use Can
-
Do National Tape (Code No. 99116) adhesive foam tape or its equivalent.
Preparing the FX-WRZ Series Sensor for operation
To prepare the FX-WRZ Series Sensor for operation, and to reinstall the sensor housing on its
mounting base:
1. Place the appropriate DIP switch overlay (based on the application) over the DIP switches. See
Figure 3: Mesh Network Application with FX-ZFR18xx series DIP switch overlay
Figure 4: One-to-One Network Application with FX-WRZ7860 DIP Switch Overlay
5
Temperature and Relative Humidity FX-WRZ Series Wireless Room Sensors Installation Instructions
