EDA-8000 Product/Technical Bulletin 3
I
nstallation
Kit Includes
●
EDA-8000-1100 Electric Damper Actuator for direct
shaft mounting
●
two No. 10 mounting screws
●
two isolator grommets
Tools Required
●
screwdriver, flat-blade, 1/4 to 5/16 inch and 1/8 inch
tips
●
drill, 5/32 inch (4 mm) and 11/64 inch drill bits,
1-1/4 inch (32 mm) hole saw
●
adjustable wrench
●
pliers
Accessories
●
D-9999-142 blade pin extension for JCI
D-1300 dampers
●
D-9999-134 blade pin extension for JCI
D-1300 dampers (includes D-3153-105)
●
D-3153-105 universal mounting bracket if mounted
on duct or wall less than 16 gauge
●
EDA-8000-101 adjustable bracket for spanning
channels or objects
Dimension
Note:
The actuator requires a minimum damper shaft
length of four inches from the mounting
surface. When determining shaft length,
consideration has to be given to channel
depth, insulation, etc. Refer to the following
dimensional drawings.
Before starting the job, obtain the damper installation
information to use as a reference when mounting the
actuator.
6 inch Minimum
for Cover
Removal, Wiring,
and Adjustments
Figure 2: Cover Removal Dimensional Requirement
No. 10 Slots for Remote
Mounting (4 Places)
2.33
(59)
1.50
(38)
0.75
(19)
6.94 (176)
8.78 (223)
9.26 (235)
4.65
(118)
4.34
(110)
(3 x 0.875) for
1/2 in. Conduit
Flexible
Grommet
(2 Required)
3.27
(83)
0.92
(23)
0.70
(18)
6.71 (174)
8.33 (212)
No. 10 Slots for
Side Mounting
(4 Places)
1
(25)
1.5
(37)
2.5 (63)
1.5 (32)
3
(75)
Figure 3: Dimensions (inches/mm)
