10
(3).
Partially tighten the (four) screws in the corners to secure panel to chassis.
(4).
Tighten the screws incrementally so that the grille rises in a level manner until
the grille meets the finished ceiling.
(5).
Once the grille is in place and tightened the sealing gasket of the grille should be
compressed to approximately 1/4 to 1/8 of an inch. Try to keep the gasket thickness as
uniform as possible for best performance.
Latch
Piping position
Swing flap moto
r
Indoor unit
Ceiling
Air outlet vent
Decorati
ve
panel
5mm to 8mm
Sealing material
Hook
Fig.13
Summary of Contents for DHMW24NKB21S
Page 27: ...19 ...
