www.johnnyseeds.com
5
10. Insert the swaged end of the partially bent pipe into
the holding strap at the end of the
short radius
bender
. Insert so that the
7
” mark
is just to the
left
of the holding strap.
11. Pull back and bend around the short radius bender
until the pipe just touches the wood screw or nail
from step 9. See photos bottom right.
12. Remove the pipe from the bender. This is Hoop #1.
Hoop #2
13. Insert the swaged end of the pipe into the holding strap at the end of the
long radius bender
. This pipe
does not need to be marked. Insert
just past the swage
to prevent canting or kinking that portion of the
pipe.
14. Perform steps 4 through 8 for the entire length of the pipe.
15. This is Hoop #2.
Hoop #3
16. Make two marks,
one at 7” and one at 12”
,
from the
non-swaged (female) end
of the next
pipe.
17. Insert the non-swaged end of the pipe into the
holding strap at the end of the
long radius bender
.
Insert so that the
12” mark
is just to the
left
of the
holding strap.
18. Perform steps 4 through 8 for the remaining length
of the pipe.
19. Insert the
non-swaged end
of the partially bent pipe
into the holding strap at the end of the
short radius
bender
. Insert so that the
7
” mark
is just to the
left
of the holding strap.
20. Pull back and bend around the short radius bender
until the pipe just touches the wood screw or nail
from step 9.
21. Remove the pipe from the bender.
22. This is Hoop #3.
7”
12
”
10.
11., 20.
16.
17.
19.
11., 20.
17.
18.
20.
20.
7617.999 Rev 06/21/2021 | AL, JG, ms
