10. Trimming the headrail
Tools required are a hacksaw and Phillips screw driver.
10. A Loosen the end cover retaining screw, slide and
remove end cover from rail.
10. B Loosen the cord guide retaining screw located
undeneath the rail.
10. C Slide cord guide and housing further up the
headrail to desired position. Re-lock the cord
guide retaining screw.
10. D Insert the trimming aid into the headrail over
the bar to your required trimming position.
10. E Using the edge of the insert as a guide, carefully
trim the headrail with a fine toothed hacksaw,
cutting through the inner bar as you do so.
10. F Remove the trimming aid. Unscrew and reposition
the centre cord guide if needed. Re-secure the
guides. Should you wish the blind to draw from
the left hand side - see points 16 and 17 overleaf
before re-securing the cord guides.
11. Fixing the cam supports
11. A The cam supports are designed for face or top
fixing to frame, wall or ceiling.
11. B Mark through the screw holes the position for
the cam supports making sure they are level and
in line, check with a spirit level.
With the cam supports removed, drill each cam
support screw position. Fix cam supports into
place using screws provided, check alignment and
level as yougo. Use the wall plugs provided for
plaster and masonary walls. We recommend for
plaster walls a wooden batten be secured first.
12. Attaching blind to the headrail
Line up the blind/loop tape with the hook tape on the
headrail and press firmly to secure the blind in place.
13. Cording the blind
For ease of assembling the headrail is pre-corded.
13. A Working vertically from where each cord will drop
from the cord guides, thread the cord through the
pocket tape. After the last row of pocket tape
thread a hook on cord toggle onto each cord.
13. B Using an upward motion as shown, thread the hook
on cord toggle into the last row of pocket tape.
Do not allow the cords to become twisted.
With the blind held in a level, vertical position,
adjust the hook on cord toggles so that equal
tension is held on each and they are level. Trim any
excess cord at a distance of 4cm from the hook on
cord
toggles.
Do not Knot the cords.
Should the cords ever become detached please
ensure when replacing that they are aligned vertically
and that the hook on cord toggles have equal
tension on each and they are level.
14. Hanging the headrail
14. A With the cam supports in the unlocked position,
mount the headrail onto the supports by resting the
front lip of the headrail onto the front of the supports.
14. B Secure by sliding the lever on the cam supports
into the locked position.
10
11
12
13
14
B
C
A
A B
D
E
F
cord guide
retaining screw
cord guide
and housing
lock
unlock
side view
lever rear
located under headrail
A
A
B
B
4cm
