7
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
Should the appliance power supply cables
need to be replaced, this must be carried
out by a Service Force agent (see page 22)
The manufacturer declines any liability
should this safety easure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance’s
rating plate. (See picture on page 5).
The appliances are supplied with 2 x 13amp independent
plugs.
In the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved BS 1363/A fuse must be
used.
Should the plug need to be replaced for any reason,
proceed as described below.The wires in the mains lead
are coloured in accordance with the following code:
Green and Yellow
- Earth
Blue -
Neutral
Brown -
Live
If you fit your own plug, the colours of the wires in the
mains lead of your appliance may not correspond with
the markings identifying the terminals in your plug.
Proceed as follows:
1.
Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter "E"or
the earth symbol
or coloured green and yellow.
2.
Connect the Blue (neutral) wire to the terminal in the plug
which is marked with the letter "N" or coloured black.
3.
Connect the Brown (live) wire to the terminal in the
plug which is marked with the letter "L" or coloured red.
4.
Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must be
secure over the outer sheath.
WARNING: A cut off plug inserted into a
13 amp socket is a serious safety (shock)
hazard.
Ensure that the cut off plug is disposed of
safely.
The plugs must still be accessible after the
appliance has been installed.
The appliance should not be connected to
the electrical supply by means of an
extension cable.
D207
GREEN & YELLOW
13 AMP. FUSE
BROWN
CORD CLAMP
BLUE
13
AMP
