Fridge freezer user guide
21
Install the freezer door handle
After
fi
nal installation and door levelling, install the freezer door
handle.
• Position the freezer door handle into the guides on the
freezer door, the set screws on the handle needs to point
downwards.
• Using the supplied Allen key tighten the two set screws
(turn in a clockwise direction – when viewed from
underneath).
Installing the water line
You will require the following component (not supplied to
connect your fridge freezer to the water supply:
• Connector
• Water pipe / tube
Connector
Waste/Pipe/Tube
Notes:
The water pressure should be 1.96~8.62 Bar or more to run
the automatic icemaker. Checkup your tap water pressure; if a
cup of 180cc is full within 10 seconds, the pressure is OK.
When installing the water tubes, ensure they are not close to
any hot surfaces.
The water
fi
lter only
fi
lters water; it does not eliminate any
bacteria or microbes.
If your water pressure exceeds 8.62 bar a pressure reducing
valve must be installed.
Use sealing tape on each pipe / tube connection to ensure
there are no water leaks.
The water pipe / tube should only be connected to your cold
water supply.
1 Connect the water pipe / tube to the fridge freezer.
2 Connect the pipe / tube to the tap connector, place the
rubber washer inside the tap connector and screw onto
the water tap.
