21
Calling up a capture memory location
1. Use the - and + buttons to select the desired level (
1-32
) on the display.
2. Push the desired memory location (1-8) in. The active stops light up.
4.11.2
General Volume
The set volume can be read on the display (
Vol:..
).
1. Push the VOL piston in.
2. Use the - and + pistons to set the volume.
3. Press the SET piston to save the volume in the memory.
4.11.3
Transposer
The Transposer function shifts the pitch by half-tone increments (from -8 to
+8). The set pitch can be read on the display (
Trans:..
).
Changing the transposer
1. Push the TRANS piston in.
2. Use the - and + pistons to set the pitch.
Programming the transposer
1. Push the TRANS piston in.
2. Use the - and + pistons to set the pitch.
3. Press the SET piston.
The volume can only be programmed when the VOL. piston is lit.
The volume change is in the memory. When the organ is switched
on again, the programmed volume will be active.
The pitch can only be programmed when the TRANS. piston is lit.
The pitch shift is not stored in memory. When the organ is switched
on again, the most recently programmed pitch will be active.
The pitch shift is stored in memory.. When the organ is switched
on again, the programmed pitch will be active.
Summary of Contents for REMBRANDT 275
Page 1: ...1 USER MANUAL JOHANNUS REMBRANDT 275 375 395 AND 495...
Page 34: ...34...
