www.joerns.com | [email protected]
Joerns Support Surface
Arise
®
LAL Mattress Replacement,
Arise LAL Overlay, Arise 1000, Arise 1000EX
Arise
®
1000 EX Mattress Setup
Remove the existing mattress from the bed.
Place the Arise 1000 EX mattress with the hose
connection at the foot end of the bed and the
therapy cells facing up. Secure the eight (8)
straps on the mattress securely to the loops
provided on the Bari10A bed frame.
Note:
These straps should not be over tightened
as they may interfere with the Bari10A bed deck
elements during width reduction.
If the therapy pad is not already on the mattress,
attach it via the longitudinal zippers to the
mattress.
Note:
This will require threading the
hose set through the control window opening
on the therapy cover located on the mattress
side at the patients left foot. Also attach the
snaps around the control panel opening from
the therapy cover to the mattress control panel
in four (4) places so that the control panel is not
obscured (Figure 2).
Hang the control unit on the foot of the bed
facing away from the bed. Attach the hose
connector marked
CPR
to the underside of the
control unit.
Plug the Fowler boost sensor into the side of the
control unit.
Plug in the control unit and the yellow
Standby
light will illuminate. Press the
Power
key.
The control unit will start and the green light
will illuminate.
Allow three to five minutes for full inflation
Select the appropriate
Comfort Adjust
setting
(Refer to “Comfort Adjust Setup” section).
The CairRails air bolsters can be inflated or
deflated as required. Locate the control knob
(Figure 2) on the lower right of the control
panel on the mattress. Next, inflate/deflate the
CairRails by moving the control knob to the up
(inflate) or down (deflate) position.
If the patient needs the extended width
functionality of the bed (36", 42" or 48") then
complete the following procedure.
Note:
this can
be accomplished with the patient on the bed:
Adjust the Bari10A bed frame with the knee
section in the flat position.
Widen the bed frame (see bed manual)
Un-strap the mattress side straps from the
Bari10A bed frame.
Un-snap the pocket that contains the
extension side cells so they are free
to inflate.
•
•
•
•
•
•
•
•
•
•
1.
2.
3.
4.
Attach the extended width mattress side
straps to the extended bed deck (
Note:
do not
over tighten).
Inflate the extension side cells by turning
the lower left knob on the mattress control
panel up. After 2-5 minutes the cells will
inflate. Leave the knob in this position to
maintain inflation.
If the patient needs the extended length
functionality of the bed (80" - 88" then complete
the following procedure.
Note:
this can be
accomplished with the patient on the bed:
Adjust the Bari10A bed frame with the knee
section in the flat position.
Extend the bed frame (see bed manual)
Un-strap the mattress foot straps from the
Bari10A bed frame.
Un-snap the pocket that contains the
extension foot cells so they are free
to inflate.
Attach the extended length mattress foot
straps to the extended bed deck (
Note:
do
not over tighten).
Inflate the extension foot cells by turning the
lower left knob on the mattress control panel
(Figure 2) up. After 2-5 minutes the cells will
inflate. Leave the knob in this position to
maintain inflation.
5.
6.
•
1.
2.
3.
4.
5.
6.
10
Figure 2
Electronic Copy: Reference Only
