▪ To carry out this step, use the delivered key for
loosening the screws. Do not forget to re-tighten the
screws afterwards.
Slide lock adjustment
▪ To unlock and lock the slide bar, turn the slide
bar lock knob counterclockwise or
Clockwise
Depth stop
When not a complete cut through the work piece is
desired, use the depth stop bolt to control
the depth of cut.
▪ Unlock the retaining pin.
▪ Raise the saw head assembly.
▪ Push the depth stop to the left to use the depth
stop bolt settings.
▪ Pull down on the saw head to check the current
setting.
▪ To change the setting, first loosen the knurled
depth stop nut on the depth stop bolt. Turn
the depth stop bolt clockwise to decrease depth and
counterclockwise to increase depth.
Tighten the depth stop nut after adjustment.
▪ If needed, push the depth stop to the right to
temporarily disable it.
Switching ON / OFF
▪ Connect the power tool to the power supply.
▪ To turn the machine on, simultaneously press
the main switch and locking button.
▪ When you want to turn off the machine, you
have to release the on/off switch.
▪ Important! Place the material you want to saw
flat on the machine surface and secure with
the clamping device so that the material cannot
move while you are cutting.
- Information on the maximum cross
section of a workpiece in a cross
- The outer diameter ranges, the bore
diameter and the thickness of the blades
can be used
Blade Diameter
255mm
Bore diameter
30 mm
Blade thickness
2.8 mm
- The maximum depth of cut
Cutting capacity, max.
(0°/90°) :72 x300 mm
OPERATING INSTRUCTIONS
Transporting the mitre saw
To transport the power tool, use the retaining pin.
Pull the mitre saw downwards and lock it in the
lowered position by pull, twist and push in the
retaining pin. That way, the saw is secured.
Pull the sawblade to the front and block by
tightening slide bar lock.
Dust and chip extraction
For integrated dust extraction, place the dust bag
on the sawdust outlet.
For external dust, you can use a vacuum cleaner
hose.
Clamping the work piece
Make sure the work piece can’t be catapulted. The
clamp is the most perfect gadget to
avoid this.
▪ Press the work piece against the fence and
between the clamp
▪ Tighten the clamp clockwise to secure the work
piece.
Adjusting of the cutting angle
▪ Position the saw in the lower position and block
it with the blocking pin.
▪ Now hold the try square (90°) against the guide
rail and the saw blade. The latter must
make complete contact with the try square. If this is
not the case, then you can adjust the
angle by loosening the counter nut and adjust with
adjustment bolts until the angle
between the blade and the turn table equals 90°.
Summary of Contents for CT0092
