jobmate YT4334-03, User Manual

Page: 6 / 15

10 11
ASSEMBLY INSTRUCTIONS
Assemble the guide bar and saw chain before operation. Follow the
operating instructions step-by-step and use the pictures provided as
a visual guide to easily assemble the product.
Chain and guide bar
> Use only the guide bar (5) and
saw chain (4) according to the
technical data of the product.
> Place the product on a suitable
À
at
surface with the cover (10) facing
upwards.
> Remove the red cap, and
loosen the retaining nut (9)
anticlockwise with the wrench (8)
and remove the nut as well as the
cover (10) (Fig. 1).
> Spread the saw chain (4) out with
the cutting edges of the chain
pointing in the rotational direction
and slide the chain into the groove
around the guide bar (Fig. 2).
Fig. 1
Fig. 2
WARNING! Read all the instructions carefully! Do
not connect the product to the power supply until it
is completely assembled! Always wear gloves during
assembly!
10
8
9
4
5
Fig. 3
Fig. 5
Fig. 4
Fig. 6
> Ensure the tension pin (24) is adjusted to far left position, turn the
tension screw (3) anticlockwise if required (Figs. 3, 4).
> Align the guide bar (5) and saw chain (4) assembly with the drive
sprocket (20) and bolt (23). Lay the saw chain around the drive
sprocket and then lower the guide bar to install it to the bolt (Figs.
5, 6). Please make sure tension pin (24) insert into bottom small hole
of guide bar
WARNING! Always use a saw chain designed as “low-
kickback” or a saw chain which meets the low-kickback
requirements! A standard saw chain (a chain which does
not have the kickback reducing guard links) should only be
used by an experienced professional operator!
Nevertheless, a low-kickback saw chain does not
completely eliminated kickback! A low-kickback or “safety”
chain should never be regarded as complete protection
against injury! Therefore always use a low-kickback saw
chain in conjunction with other kickback protection devices
such as the front guard/chain brake!
24
3
24
8
24