jobmate 054-1200-0, Owner'S Manual

Page: 7 / 23

7
Do not incinerate the battery
. It can
explode in a fire.
Do not use an extension cord . Plug the
charger cord directly into an electrical
outlet.
Use the charger only in a standard 120 V
60 Hz electrical outlet
.
Charge the battery only with the charger
supplied with the drill
.
Do not use the charger in wet or damp
conditions
. It is intended for indoor use
only. Do not use the charger near sinks or
tubs. Do not immerse the charger in water.
Do not allow the cord to hang over the
edge of a table or counter or touch hot
surfaces
. The charger should be placed
away from sinks and hot surfaces.
Do not use charger to charge any
batteries other than the drill batteries
.
Other batteries may explode.
Do not operate charger if cord or plug is
damaged
. Replace damaged cord and plug
immediately.
Do not operate charger if it has received
a sharp blow
, been dropped or otherwise
damaged in any way. Have a qualified
technician examine the charger and repair
it if necessary. Do not disassemble the
charger.
Do NOT charge batteries when the work
area or the battery temperature is at or
below 0° C (32° F) or above
45° C (113° F).
Unplug the charger when not in use
and
before cleaning or maintenance.
Do not abuse the cord . To reduce the risk
of damage to the electric cord or plug,
never carry the charger by the cord or yank
the cord to pull the plug. Always grasp the
plug and pull to disconnect. Always keep
the cord away from heat, oil and sharp
edges.
Do NOT leave the charger plugged in for
longer than 4 hours.
The battery will be
fully charged within 4 hours. Leaving the
charger plugged in for longer than 4 hours
may damage the battery and void the
warranty.
NOTE: See Pages 19 & 20 for
detailed information on exercising the
battery for peak performance and for
disposal of defective batteries.
BATTERY & CHARGER SAFETY
SAVE THESE INSTRUCTIONS FOR REFERENCE