13
ON-BOARD SCREWDRIVER BIT
STORAGE
Convenient on-board screwdriver bit
storage (1) is provided at the rear of the drill
housing (see Fig. 3).
TORQUE ADJUSTMENT
Your drill is equipped with an adjustable
torque clutch for driving different types of
screws into different types of materials. The
proper setting depends upon the type of
material and size of screw being used.
Adjust the torque setting as follows:
1.
Identify the torque settings located on
the torque adjustment ring (1) (see
Fig. 4).
2.
Rotate adjustment ring to align the
correct torque setting number with the
torque indicator arrow (2). See chart
below for correct torque settings.
1
–4 For driving small screws
9
–11 For driving screws into soft &
5
–8 For driving medium sized
screws into soft materials
9
–12 For driving screws into soft &
medium-density materials
13
–14 For driving screws into
hardwood
15
–16 For driving large screws
Use highest setting for drilling.
This position is marked with a
picture of a drill bit on the torque
adjustment ring.
FORWARD/REVERSE SWITCH
The forward/reverse switch (1) is
conveniently mounted above the trigger
switch (2) (see Fig. 5). To make the drill
rotate clockwise (for drilling) push the
forward / reverse switch to the left. To make
the drill rotate counter-clockwise for
removing screws, push the forward /
reverse switch to the right.
NOTES:
a) Never change position of the
forward/reverse switch while chuck is
turning.
b) The trigger switch will NOT function with
the forward/reverse switch in the middle
position.
ASSEMBLY & OPERATION
Fig. 4
Fig. 2
Fig. 3
Fig. 5
Summary of Contents for 054-1200-0
Page 11: ...11 CARTON CONTENTS...
