24
2.
Prepare cable and bare
the end 7mm of each
wire. Insert the cable
through the nut and
middle sleeve.
3.
Insert the bared wires U,
V, W and PE into the
corresponding four holes
of the connector terminal
and then fully tighten all
screws. The phase
sequence of each hole is
signed around the holes.
Please note that wire U
must be connected to
hole 1, wire V to hole 2,
wire W to hole 3, and
wire PE to hole
.
4.
After fasten wires with
terminal, combine every
component together, and
screw them tightly.
Step2:
Plug the AC connector into the motor terminal at the bottom of inverter,
