01/31/2006 Rev 1
5. Make sure that no more than one or two threads are showing on the inside of the hole saw. See
Figure 4.
6. Pass tube into tube vise and position as required for notch and tighten the tube vise on the
material.
7. Mount a 1/2" drive drill motor on the cutter shaft.
8. Follow the hole saw manufacturer's recommendation on the use of cutting/cooling fluids.
WARRANTY
1. One year limited warranty on tube notcher.
2. Warranty item must be sent to JMR Manufacturing postage pre-paid for inspection. JMR
Manufacturing will replace or repair item at their discretion.
3. JMR Manufacturing makes every attempt to satisfy customers as quickly as possible.
4. JMR Manufacturing will not accept any responsibility for personal injury or property damage
arising from the failure of any parts manufactured and/or sold by JMR Manufacturing, LLC.
