Inventory with the MT2070
8
Connecting the USB Cable Directly to the
Scanner (without a cradle)
1)
Plug the RJ-45 connector end of the CBA-U01-
S07ZAR (gray) USB cable into the bottom of the
MT2070 scanner as shown in Figure 1. Push it in
firmly to make sure that it locks into place and
makes good contact.
Note
: Removing the RJ-45 connector from the
scanner is a bit tricky. Because the connector is
recessed into the bottom of the scanner, you will need
to use something long and narrow (such as a small
screwdriver) to carefully release the small plastic tab,
so that you can pull it out. Because of this, you may
want to use a cradle instead.
2)
Plug the USB end of the cable into a free USB port on your computer.
Connecting the Scanner to the Computer via a STB-2000 Cradle
1)
Connect the cradle to the computer via the USB cable
and connect the power, as follows:
a.
Connect the CBA-U01-S07ZAR (gray)
USB cable to the bottom of the cradle (see
Figure 2 at the right).
b.
Connect the round connector of the power
adapter cord to the round port on the bottom
of the cradle. (see Figure 2)
2)
Connect the power cord to the power adapter and an
electrical outlet.
3)
Plug the USB end of the cable into a free USB port on
your computer.
4)
Put the MT2070 scanner into the cradle as shown
below. Rest the head of the scanner in the top of the
cradle first, and then push the handle until it clicks
into place, engaging the contacts in the cradle and device.
Figure 1
Figure 2
