Problem
Cause
Solution
Little or no painting
material being
sprayed
Nozzle clogged
Clean
Suction tube clogged
Clean
Material volume setting turned
too low (-)
Increase paint volume setting (+)
Suction tube loose
Re-insert tube
No pressure build-up in the
container
Tighten container
Air filter clogged
Change
Material or paint
leaking
Nozzle loose
Tighten
Nozzle worn
Replace
Nozzle seal worn
Replace
Material build-up on air cap
& nozzle
Clean
Atomisation too
course
Viscosity of material too high
Thin material by 10%
Material volume too large
Decrease paint volume (-)
Material volume too high (+)
Decrease paint volume (-)
Nozzle clogged
Clean nozzle
Air filter clogged
Clean or change
Too little pressure build-up in
the container
Tighten container / check seal
Spray jet pulsates
Material in container is running out Refill container
Air filter is clogged
Clean / replace
Spray material is too viscous
Thin material by 10%
Pattern runs
Applying too much painting
material
Decrease paint volume setting (-)
Too much overspray
Gun too far from spray object
Reduce distance from object
Too much painting material
applied
Decrease paint volume setting (-)
17
18
This product is unconditionally guaranteed for one year against all defects of workmanship
and materials. This guarantee does not affect your statutory rights. If you have any problems
or queries about this product please contact JML.
JML Customer Helpline:
0800 781 7831
Disposal and the environment
This product is covered by the waste electrical and electronic equipment
(WEEE) regulations. It should not be discarded with normal household waste,
but taken to your local collection centre for recycling. For further information,
please contact the local authority or approved disposal agency.
Troubleshooting
Guarantee
Technical Information
Technical Information
Model number
Q1P-WYT10-800
Power (W)
400W
Voltage (V)
230 -240V
Rating frequency
50Hz
Protection class
II
Spraying capacity
380ml/min
Container capacity
800 ml
Mass of Paint Sprayer
1.13kg
Ingress protection
IP20
PSE_Instruction Manual_A.indd 18-19
24/10/2011 13:33
