SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-18
– JLG Lift –
3121773
6.5
PLATFORM/REMOTE CONTROL SERVICE MENU
Service Button
(See Figure 3-3. on page 3-10)
A SERVICE button
(item 6)
is present on the remote control
which allows to view the status of the machine parameters
and is an aid in the safety checks of the machine.
By pressing the SERVICE button a numerical menu is dis-
played on the LCD display
(item 15)
, each of these menu
items can be accessed by pressing the corresponding plat-
form/remote control buttons
(numbered 1 thru 9)
below the
buttons.
1 - INPUT
2 - LANGUAGE
3 - ERRORS
4 - RAMPS
5 - CURRENT
6 - W. HOURS
7 - SETUP
8 - JOYSTICK
9 - EXIT
MENUS 4; 5; CANNOT BE ACCESSED
Menu Input
The signals that arrive at the board from the various sensors
mounted on the machine and from the platform/remote
control commands are displayed. The status of the input and
the following selection to scroll the menu appears for each
screen:
1 - PREV - access the previous input
2 - NEXT - access the successive input
9 - ESC - escape from the INPUT menu
LIGHTLIFT SELF-PROPELLED AERIAL PLATFORM - X700AJ
ST1 GND A
Both ON indicate the stabilizer 1 rests on the ground.
ST1 GND B
ST2 GND A
Both ON indicate the stabilizer 2 rests on the ground.
ST2 GND B
ST3 GND A
Both ON indicate the stabilizer 3 rests on the ground.
ST3 GND B
ST4 GND A
Both ON indicate the stabilizer 4 rests on the ground.
ST4 GND B
ST1 OPEN A
Both ON indicate the stabilizer 1 is completely open, TOTAL
AREA.
ST1 OPEN B
ST2 OPEN A
Both ON indicate the stabilizer 2 is completely open, TOTAL
AREA
ST2 OPEN B
To
order go
to
Discount-Equipment.com
