SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
3-18
31215090
ONLY FOLD DOWN THE RAILS WHEN THE MACHINE IS IN THE STOWED (PLATFORM
FULLY LOWERED) POSITION. DO NOT RAISE THE PLATFORM WITH THE RAILS FOLDED
DOWN. THE RAILS MUST BE IN THE UPRIGHT POSITION AND PROPERLY PINNED
WHEN RAISING THE PLATFORM.
1.
Remove the platform control station from its bracket and
place on the platform floor. Remove pin from the rear gate
top rail, then fold in against the right side rail.
2.
Remove the top rail pins at the front of the machine. Slide
the deck extension top side rails towards the rear of the
machine.
NOTE:
Place pins in the lower holes of the extension side top rails before
folding main platform side rails down.
3.
Remove the pins at the front mid rails, then fold down the
front panel towards the platform floor.
4.
Fully open the swing gate and hold. Fold down the right side
rail, then fold down the left side rail.
NOTE:
For machine R2632, reverse steps 3 and 4. Open and hold the
swing gate, then fold down right and left rails, then fold down
the front panel.
To return the rails to the upright position, unfold the rails in the
reverse sequence in which they were folded. Firmly pull the rails into
position and secure the pins onto the rails.
AFTER THE RAILS HAVE BEEN FOLDED DOWN, USE EXTREME CAUTION WHEN EXITING
AND ENTERING THE PLATFORM. ENTER AND EXIT PLATFORM ONLY AT THE GATE AREA
AND LADDER PROVIDED.
IF DRIVING MACHINE WITH THE PLATFORM CONTROL STATION FROM GROUND, DO
NOT HANG THE CONTROL BOX ON ANY PART OF THE MACHINE WHILE DRIVING. HOLD
THE CONTROL BOX AND KEEP AT LEAST 3 FT (1 M) DISTANCE FROM MACHINE.
To
order go
to
Discount-Equipment.com
