SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
3-8
31215084
Platform/Ground Select
The Platform/Ground Select switch directs power to the Ground
or Platform controls as selected. For power, the POWER/EMER
-
GENCY STOP switch must also be pulled out (on).
Raising & Lowering
To raise or lower the platform, either use Lift or Lower function
and hold switch until desired elevation is reached.
DO NOT LOWER WITHOUT COMPLETELY RETRACTING PLATFORM EXTENSION.
Leveling Jacks (If Equipped)
Once the leveling jacks leave the stowed position (fully
retracted) but are not fully extended, the lift and drive functions
are cut out.
After all four jacks are extended and touch a solid surface only
the drive function is cut out. Drive function is restored once the
jacks are stowed (fully retracted) again.
Platform Extension
The machine is equipped with a mechanical extension deck. To
extend the deck, lift handle up on the left and right side of the
platform to release the latch and use the handle to push the
extension deck out. When the deck reaches the end of its travel,
push handle down to latch, this will lock and hold the deck in
place. To retract the deck, reverse operation.
Platform Handrails Fold Down Procedure (If Equipped)
ONLY FOLD DOWN THE RAILS WHEN THE MACHINE IS IN THE STOWED (PLAT
-
FORM FULLY LOWERED) POSITION. DO NOT RAISE THE PLATFORM WITH THE
RAILS FOLDED DOWN. THE RAILS MUST BE IN THE UPRIGHT POSITION AND
PROPERLY PINNED WHEN RAISING THE PLATFORM.
1.
Remove the two pins from platform extension gate
and fold gate to the left side handrail.
2.
Remove the pin from extension left side handrail, lift
up and fold down handrail onto platform deck.
3.
Remove the pin from extension right side handrail, lift
up and fold down onto platform deck.
4.
Remove the two pins from rear handrail, lift up and
fold gate down onto platform deck.
5.
Lift up left handrail, fold handrail down onto platform
deck.
6.
Lift up right handrail, fold handrail down onto plat
-
form deck.
AFTER THE RAILS HAVE BEEN FOLDED DOWN, USE EXTREME CAUTION WHEN
EXITING AND ENTERING THE PLATFORM. ENTER AND EXIT PLATFORM ONLY
AT THE GATE AREA AND LADDER PROVIDED.
To
order
go
to
Discount-Equipment.com
