SECTION 2 - PROCEDURES
2-14
– JLG Sizzor –
3120791
.
Steer Relief Adjustment
1.
Install a pressure gauge at gauge port MP, located
on the lower right side of the valve body. The port is
identified by a stamping on the valve body.
2.
Activate the Steer Right function and check Steer
pressure. If necessary, adjust Steer pressure to 1500
psi (103 bar).
3.
Activate the Steer Left function and check Steer
pressure. If necessary, adjust Steer pressure to 1500
psi (103 bar).
4.
Remove the pressure gauge from gauge port MP.
2.15 DRIVE AXLE REPAIR
Axle Removal
1.
Chock the front wheels of the machine securely.
2.
Using a suitable jack or other lifting equipment, raise
the rear end of the machine. Support the machine
on suitable jack stands or other appropriate support-
ing equipment.
3.
Carefully remove the five wheel nuts securing each
wheel and tire assembly to the drive axle and
remove the rear wheel and tire assemblies.
4.
With the axle properly supported, remove the eight
locknuts and washers securing the u-bolts to the
frame, then carefully remove the four u-bolts.
Remove the supports and remove the drive axle
from the machine.
Figure 2-15. Valve Components
Summary of Contents for 26MRT
