JLG 10VP, Operators & Safety

Page: 21 / 52

SECTION 2 - PREPARATION AND INSPECTION
3120727 – JLG Lift – 2-7
Figure 2-5. Lubrication Chart.
2
1
3
4, 5
6
Table 2-1.Lubrication Intervals for Various Components
ITEM COMPONTENT
NO/TYPE
LUBE POINTS
LUBE/METHOD
INTERVAL HOURS
COMMENTS
3
M ONTHS
150 Hrs.
6
MONTHS
300 Hrs.
1
YEAR
600 Hrs.
2
YEARS
1200 Hrs.
1 Hydraulic Oil Fill To Line on
Reservoir
5 Qt. Reservoir HO - Check Hyd. Oil
Level
HO - Change Hyd. Oil
✔
Check hydraulic oil every 10 hrs.
Change hydraulic oil every 1200
hrs.
2 Drive Wheel
Bearings
4 - Grease Fittings MPG- Pressure Gun
✔
3 Drive Wheel
Gear Box
2 - Gear Box Gear Oil
Change only when serviced -
requires 175cc’s to fill.
4 Caster Axles 2 - Grease Fitting MPG - Pressure Gun
✔
5 Swivel Raceways 2 - Front Casters MPG - Pressure Gun
✔
6 Mast Chains * 2 - Per Section Chain Lube - Brush or
Spray
✔
Inspect, lubricate if dry or rusting.
* Applies Only to Mast Sections with Chains.
Key to Lubricants: MPG - Multipurpose Grease
HO - Hydraulic Oil - Hydraulic oils must have anti-wear qualities at least to API Service Classification GL-3, and sufficient
chemical stability for mobile hydraulic system service. JLG Industries, recommends Mobilfluid 424
hydraulic oil, which has an SAE viscosity of 10W-30 and a viscosity index of 152.
For cold weather applications, i.e. when temperatures remain consistently below + 20°F (–7°C) JLG
recommends using Mobil DTE 13 hydraulic oil.
Notes: 1. Be certain to lubricate like items on each side of the machine.
2. Recommended lubricating intervals are based on normal use. If machine is subjected to severe operating conditions,
such as a high number of cycles, location, corrosive/dir ty environment, etc., user must adjust lubricating requirements accordingly.
3. Prior to checking hydraulic oil level, operate machine through one complete cycle of lift function (full up and down). Failure to do so will
result in incorrect oil level reading on the hydraulic reservoir.