Continued on Next Page
SMS-B-X5E70 INSTR_SKU# 11339
S T E P 2 3
Remove the speed clip from the location indicated by the
left arrow, and relocate it to the location indicated by the
right arrow as shown.
S T E P 2 2
Using a 1” hole saw, drill a hole at the intersection and slide
a U-Nut through the driled hole, aligning it with the factory
hole as shown.
S T E P 2 1
Note:
Steps 21-22
are only necessary on vehicles not
equipped with the factory bracket shown in
Step 20
.
Locate the two holes in the floor, and mark their
perpindicular intersection as shown.
S T E P 2 0
Remove the nut from the factory bracket as shown. Retain
the nut for use in
Step 26
.
If this factory bracket isn’t present, substitute
Steps 21-22
.
Page 4 • JL Audio, Inc 2012
S T E P 2 5
Using a pair of 1/4” - 20 x 1” Bolts, 1/4” Lock Washers, and 1/4”
Flat Washers, attach the Side Bracket to the Stealthbox® as
shown, and hand tighten.
S T E P 2 6
Attach 12 AWG Speaker Cable to the Stealtbhox®, and place
the enclosure into position, aligning the hole in the Side
Bracket with the factory bolt as shown. Secure the Side
Bracket to the floor using the factory nut removed in
Step
20
.
On vehicles not equipped with the factory bracket and bolt,
secure the Side Bracket to the U-Nut installed in
Step 22
using a 1/4 - 20 x 1/2” Bolt.
S T E P 2 4
Pictured is the included hardware needed to mount the
enclosure, along with the factory nut removed from
Step 20
.
S T E P 2 7
Slide the Stealthbox® as far back toward the rear of the
vehicle as possilbe. Using an open-ended wrench, tighten
the two 1/4” - 20 x 1” Bolts to secure the Side Bracket to the
Stealthbox®.
