Continued on Next Page
SMS-C-CTS INSTR_SKU# 011357
Page 9 • JL Audio, Inc., 2013
S T E P 4 4
Push the driver’s side trunk liner back into position and cut
three holes in the liner to allow the three 3/8 - 16 x 2-1/4” Set
Screws to pass through. Cut a small “X” in the trunk liner to
allow the 12 Gauge Speaker Cable to pass through as well.
S T E P 4 8
Premium System Only:
Connect the 16 Gauge Speaker Cable for the dash outputs
to the outputs for Channels 3-4. Connect the 16 Gauge
Speaker Cable for the dash inputs to a pair of Speaker to RCA
Adaptors, and plug them into Inputs 3-4.
S T E P 4 3
Base System Only:
Cut the wires indicated in Step 20 three inches away from
the plug.
Route 5 pairs of 16 Gauge Speaker Cable to the factory
amplifier location. Connect a pair to each side of both the
plug side and wire side of the cut wires. Wires connected to
the plug side will be for input and wires connected to the
wire side will be for output. Route the 12 Gauge Speaker
Cable to the Stealthbox® location.
S T E P 4 7
Connect the Power, Ground and Remote Turn-on to the
Amplifier. Connect the 12 Gauge Speaker Cable to the
subwoofer channel. Connect the 16 Gauge Speaker Cable
for the subwoofer output to a Speaker to RCA Adaptor and
Y-adaptor, and plug it into the Sub Inputs.
Connect the 16 Gauge Speaker Cable for the door outputs
to the outputs for Channels 1-2. Connect the 16 Gauge
Speaker Cable for the door inputs to a pair of Speaker to RCA
Adaptors, and plug them into Inputs 1-2.
S T E P 4 2
Base System Only:
Use the color code below for
Steps 43 and 47
.
L Door (+) = gray
L Door (-) = tan
R Door (+) = dark green
R Door (-) = light green
Sub (+) = blue/white
Sub (-) = green/black
S T E P 4 6
Slide a 3/8” Flat Washer, a 3/8” Lock Washer, and a 3/8 - 16
Hex Nut onto each of the three 3/8 - 16 x 2-1/4” Set Screws
and fully tighten.
Reinstall the subwoofer.
S T E P 4 1
Premium System Only:
Cut the wires indicated in Step 20 three inches away from
the plug.
Route 9 pairs of 16 Gauge Speaker Cable to the factory
amplifier location. Connect a pair to each side of both the
plug side and wire side of the cut wires. Wires connected to
the plug side will be for input and wires connected to the
wire side will be for output. Route the 12 Gauge Speaker
Cable to the Stealthbox® location.
S T E P 4 5
Using a Phillips head screwdriver, remove the subwoofer
from the Stealthbox®. Connect the 12 Gauge Speaker Cable
to the terminal cup, and place the empty enclosure into
position, allowing the three 3/8 - 16 x 2-1/4” Set Screws to
pass through the holes in the back of the enclosure.
