Continued on Next Page
SMS-C-CTS INSTR_SKU# 011357
Page 8 • JL Audio, Inc., 2013
S T E P 3 6
Pictured is the Amplifier Bracket and associated mounting
hardware.
S T E P 4 0
Premium System Only:
Use the color code below for
Steps 41 and 47-48
.
L Door (+) = gray L Dash (+) = tan
L Door (-) = tan L Dash (-) = yellow
R Door (+) = dark green R Dash (+) = green
R Door (-) = light green R Dash (-) = violet
Sub (+) = green/black
Sub (-) = blue/white
S T E P 3 5
Remove the factory subwoofer.
Note: Failure to remove the factory subwoofer will limit the
performance of the Stealthbox®.
S T E P 3 9
Slide a 1/4 Flat Washer over each of the four 1/4 - 20 Pan
Head Bolts and drop them down from the top through the
holes made in the previous step.
Secure the Amplifier Bracket from the underside using four
1/4 - 20 Keps Nuts.
Secure the Amplifier to the Amplifier Bracket using four
Speed Clips and four #8 x 3/4” Pan Head Screws.
S T E P 3 4
Remove the four factory subwoofer mounting bolts.
S T E P 3 8
Drill 3/8” holes on the marks made in the previous step.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a reduction
in your weekly pay.
Always wear eye protection when drilling!
S T E P 3 3
Unclip and remove the rear deck.
S T E P 3 7
Position the Amplifier Bracket as shown, and mark the
mounting hole locations on the underside of the rear deck.
