JL AUDIO
MX10IB3-SG (LED)
3
A l l s p e c i f i c a t i o n s a r e s u b j e c t t o c h a n g e w i t h o u t n o t i c e .
BEFORE YOU BEGIN INSTALLING
• Check with your local waterway authority for any regulations regarding the
use of accent/speaker lighting on your vessel.
• Turn off the audio system. It is also advisable to disconnect your battery
system whenever performing installation work.
• Before cutting, drilling or inserting any screw, check clearances on both
sides of the planned mounting surface. Also check for any potential
obstacles, such as wiring harnesses, fuel lines, hydraulic lines, etc. Check
both sides of the vessel before cutting any holes.
• If you are running cables through bulkheads, drills holes for the cable and
use a urethane or plastic grommet to protect the wire from chafing in the
hole. Make sure that the cables will clear any mechanical devices in the boat
and secure them with wire ties.
• Wear protective eyewear at all times and a dust mask and gloves when
drilling or cutting.
INTERCHANGEABLE LOGO BADGE
Interchangeable Logo Badges for Sport Grille model subwoofers are
included to further customize your installation. The design of the Sport
Grille allows for the JL Audio logo to be added in your choice of included
colors and oriented in the manner that best suits your installation.
NOTE: A left and a right badge of each color is included. These two
different orientations ensure the “JL Audio” Logo will read correctly
wherever positioned (most commonly the 3:00 or 9:00 position).
Remove the adhesive backing from the badge and affix the badge to
the grille using the small positioning hole as a guide. See diagram below.
3:00 Position
9:00 Position
The enclosure recommendations listed are external dimensions which assume the use of 3/4” (19mm) thick material. If you are using 5/8” (16mm) thick material, subtract 1/4”
(6.5mm) from each dimension. Do not use any material with a thickness of less than 5/8” (16mm) as this may compromise the rigidity of the enclosure.
All enclosure volumes listed are net internal volumes! Box volume displacement, port displacement and brace displacement must be added to obtain the final gross internal
volume. All enclosure dimensions listed have already taken this into account.
Subwoofer
Recommended Sealed Design
Volume
(net int.)
External Dimensions
(
W
idth x
H
eight x
D
epth)
F3
(Hz)
Fc
(Hz)
Qtc
MX10IB3
2.0ft
3
56.6 litres
18 in. x 18 in. x 14.5 in.
457 mm x 457 x 368 mm
42.9
53.66
0.967
Sealed Design
ENCLOSURE SPECIFICATIONS
NOTE: The MX10IB3 Marine Subwoofer is not recommended for use in Ported Enclosures.
The MX10IB3 subwoofer is designed for infinite-baffle operation with a large volume of air behind it (at least 2 cu. ft. / 56.6 l).
For best performance, the installation location/compartment must remain unoccupied and free of boating equipment
(safety gear, life jackets, etc.). If you decide to build a dedicated enclosure, you may refer to the suggested design below.