2
| JL Audio - MLC-RW Owner’s Manual
FCC Compliance Statement
This equipment has been tested and found
to comply with the limits of Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If
this equipment does cause harmful interference
to radio or television reception, the user is
encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase separation between the equipment
and the receiver.
- Connect the equipment to an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate
this equipment.
Connections
Safety Considerations
• Install the controller module in a dry, well-
ventilated location that does not interfere with
factory-installed systems. Do not install where
it will be directly exposed to the elements.
• Do not mount this product in an engine
compartment or areas of extreme heat.
Areas exposed to a heater or hot air should
also be avoided.
• Securely mount this product so that it does not
come loose in the event of a collision, sudden
jolt or as a result of repeated vibrations during
normal use.
• Check before drilling to make sure that you will
not be drilling into an exterior panel/hull, fuel
tank, gas/brake line, wiring harness or other
vital system.
• Do not run system wiring outside or underneath
the vehicle/vessel. This is an extremely
dangerous practice, which can result in severe
damage/injury.
• Protect all system wires from sharp edges and
wear by carefully routing them, tying them
down and using grommets and loom where
appropriate. Secure all wiring using cable ties or
wire clamps, as needed.
Panel-Mounting Rotary Encoder
ROTARY ENCODER
POWER CONNECTIONS
+12VDC* (Yellow)
GROUND (Black)
ILLUMINATION
+Main RGB (White)
–Red RGB (Red)
–Green RGB (Green)
–Blue RGB (Blue)
Under-Dashboard Mounting Rotary Encoder
Gasket
Threaded Collar
Mounting Bracket
1" Mounting Hole
Gasket
Threaded Collar
* Install a fuse at the +12VDC Power Wire
(Yellow) connection point that is appropriate for
the total current draw of all LED circuits.
