JL Audio 699440990431, Owner'S Manual

Page: 6 / 12

6
| JL Audio - C1-650 Owner’s Manual
SURFACE-MOUNT INSTALLATION
1) Remove the vehicle panel and check to ensure that
the mounting screws will have adequate clearance.
2) Place the surface-mount fixture on the
vehicle panel at the desired mounting location
with the mounting screw holes positioned
vertically, at twelve and six o’clock.
3) Mark the location of the two mounting screw
holes and the approximate center of the
right rectangular cutout (for the wires).
4) Using a 1/16-inch (1.5 mm) drill bit, drill a pilot
hole through the panel at the two screw locations.
5) Using a 1/4-inch (6 mm) drill bit, drill
the hole for the tweeter’s wires at the
location you marked in step 3.
6) Screw the surface-mount fixture to the
vehicle panel using the supplied #6
sheet metal screws (hand-tighten).
7) Feed the tweeter wires through the rectangular
hole in the mounting fixture and the 1/4-inch hole
you drilled in the panel. Then, snap the tweeter
into the surface-mount fixture.
8) Connect the tweeter’s wires to the wire leads from
the crossover, observing correct polarity.
9) Re-install the vehicle panel, taking care to
route the new wiring so as not to interfere
with any vehicle mechanisms (window
mechanisms, for example).
DIAGRAM D:
Surface-Mount Tweeter Installation
CLICK!