JL Audio 699440990431, Owner'S Manual

Page: 3 / 12

3
Due to ongoing product development, all specifications are subject to change without notice.
C1-650 SPECIFICATIONS:
Continuous Power Handling: 50 Watts
Recommended Amp Power:
10-75 Watts per channel (RMS)
Efficiency: 90.5 dB @ 1W / 1m | 96.5 dB @ 1W / 0.5m
Sensitivity:
93.0 dB @ 2.83V / 1m
Nominal Impedance: 4 ohm
Frequency Response:
48 Hz - 24 KHz ± 3 dB
Woofer:
Injection-molded, mineral-filled, polypropylene cone
Rubber, positive roll surround
1.0 in. (25 mm) diameter voice coil
Flat, Conex® spider with integrated lead wires
Ferrite Magnet
Tweeter:
Edge-driven, silk-suspended aluminum dome
0.75 in. (19 mm) diameter diaphragm / voice coil
Ferrofluid cooling / damping
Neodymium magnet
Crossover:
Natural roll-off, low-pass
2nd order, high-pass filter with inductor and
electrolytic capacitor
Included Components and Parts:
• Two (2) C1-650cw 6.50-inch (165 mm) woofers
• Two (2) C1-075ct 0.75-inch (19 mm) tweeters
• Two (2) surface-mount tweeter fixtures
• Two (2) C1-075cthp in-line, high-pass filters on
4 ft. (1.2 m) wire harnesses
• Two (2) metal spring clips (for tweeter flush-mounting)
• Eight (8) #8 x 0.75-inch (19mm) sheet metal screws
• Eight (8) #8 x 0.25-inch (6mm) thread forming screws
• Four (4) #6 x .625-inch (22 mm) sheet metal screws
• Eight (8) mounting clips
• Two (2) 4.7 mm female crimpable connectors
• Two (2) 2.8 mm female crimpable connectors
• Two (2) 10mm stud bolts with fixed M4 nut
• Two (2) 25mm stud bolts with fixed M4 nut
• Two (2) M5 nuts
• Two (2) multi-application speaker adaptor rings
GETTING STARTED
• Turn off the audio system. It is also
advisable to disconnect the negative (–)
terminal of your vehicle’s battery whenever
performing installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as window tracks and motors,
wiring harnesses, etc. Check both sides of the
vehicle, many vehicles are not symmetrical!
• Always wear protective eyewear.
SPEAKER PLACEMENT CONSIDERATIONS
Grilles are not included with C1 speakers, as they
are designed for installation into OEM (factory)
speaker locations, located behind factory grilles.
Should you need grilles, you will need to purchase
aftermarket grilles separately.
WA R N I N G
!!
Prolonged exposure to sound pressure levels in
excess of 100dB can cause permanent hearing
loss. These high-performance loudspeakers can
exceed this level. Please exercise restraint in their
operation in order to preserve your ability to enjoy
their fidelity.