2. Signal line connection (DMX)
Use the RS-485 cable that meets the specifications: shielding,
120ohm characteristic impedance, 22-24 AWG, low capacitance
reactance. Do not use microphone cables or cables with different
characteristics. Terminals must be connected with 3 or 5 pin XLR
type male / female connectors. A 120ohm impedance matching
resistor (minimum 1 / 4 W) must be inserted between terminals
2 and 3 of the terminal plug.
Important note: lines can not be contacted or contacted with
metal shells.
Figure 1 DMX signal line connection diagram
3. Installation of lamps and lanterns
The lamps can be placed horizontally, slant and upside down.
It is necessary to pay attention to the installation method when it
is slant and upside down.
As shown in Figure 2, before positioning the lamp, to ensure
the stability of the installation location, when the reverse hanger
is installed, the lamp must be ensured not to fall down on the
support frame, and the safety rope needs to be hung through the
Summary of Contents for LED300W
Page 19: ......
