Jimmy BX7 Pro, User Manual

Page: 5 / 60

3
Use of the Product
Insert the power cord into the machine and plug into the socket. Press on/off button,the
machine is in vaUV+tapping mode and all indicators light up.Press the mode button
to switch the machine to vacuuming mode.Press the mode button again to switch
the machine to UV+vacuuming mode.Press the mode button again to switch back to the
UV+vacuuming mode.Press on/off button again, the machine stop working.(The LED
display area has the dust sensor function. When in clean state, the dust concentration light
turns blue. When in dirty state, the dust concentration light turns red.As the dust concentration
decreases, the dust concentration light slowly changes from red to blue.)
Note:
1.When the LED display shows brush trapped mode and the icon flash,please clean the filter and brushroll in
time.
2.For safety reasons, the UV light only works within 3cm above object as well as less than 30 inclination
degrees. Otherwise, the UV light will automatically turn off.
3.Do not touch the air outlet on the bottom of the machine in case of hand scald.
LED Display
Cleaning and Maintenance
Note:
1.Filters are available at dealers.
2.It is recommended to clean the dust cup after each
use. When the filter is blocked due to excessive dust
accumulation, it needs to be cleaned and replaced if
necessary.
Dust Cup Cleaning
1.Turn off the machine and unplug the power
cord. Then press the release button and lift
upward.(Figure 1)
Vacuum Mode
Brush trapped Mode
(When the dust is full
or brush trapped, the
icon flashes.)
(Indicate dust
concentration change)
UV Mode
Tap Mode
Dust concentration light
1
Release button