3
1.
Choose a flat ground make sure there are no stone, gravel, glass, and any other sharp and edgy objects.
2. Take out the product from package and check if any parts missing, unfold it on the ground, lay flat, locate and
open inflation valve(s).
3. It is recommended that you use only a hand or foot pump for inflation.
Caution:Do not use the high-pressure air to inflate! Do not over-inflate!Never image to inflate the products
with mouth, as it will be so much difficult.
4. Slowly Inflate all parts and accessories until full one by one. Close and press all valves tightly after inflation to
firm and supportive.
CAUTION: It needs one adult to set up the product and it will let you quickly use the product within 10 minutes.
NOTE: When using this product, ensure that the valves are accessible to the user and remain out of the water.
5. After use, open and squeeze valves to release air, or insert a slim object such as a deflation tube to hold valve
inner stopper open. Being careful not to puncture your product or force air out of product. Allow air to escape
slowly and naturally.
STORAGE AND MAINTENANCE
Clean the product with clear water, then leave it in shady and cool place for airing, fold it into original package and
place it indoor for next use.
Pay attention to the fact that no sharp edges are shaped in the plastic foil while folding up the item. In winner, the
pool is not allowed to be placed at a temperature that is below 5 °C, otherwise the plastic film would be damaged.
Caution: Do not use the alkali or acid detergent to clean product! Do not leave product exposed under
sunlight directly because it will shorten the using-life of product.
WARNING: Noncomplince of the maintenance rules may result in serious hazards for health and especially
for the children.
Repair Patch Instructions
(Small pinhole and small puncture leaks can be repaired with the included repair patch)
a) Locate the leak place.
b) Deflate the air.
c) Clean the area surrounding the leakage and wipe up all water from the surface.
d) Take out the repair patch, cut it into required shape and size, which should be litter larger than the leaking area,
put the patch on leaking area and press firmly.
e) You can use it again after 24 hours drying of the repaired position.
If the damage is bigger than 1” (2.5cm), we recommend using a Silicone or rubber based glue for repair.
Please read warning statement on glue prior to use.
Shanghai Jilong Plastic Products Co. Ltd.
No. 460 Lanxue Road, Huanglou, Pudong Area, Shanghai, 201205, P.R. China