Jigsaw provide the solution piece by piece
Feel the Future of Heating. Step out of the Shade and into the Sun
8
9
INSTALLATION ADVICE
MOUNTING BRACKETS
• Should not be installed in contact with the floor.
• The equipment must not be located immediately below a
socket-outlet.
• The equipment shall not be used if the panel is damaged.
• The supply cord cannot be replaced. If the cord is
damaged the appliance should be scrapped.
• Should not be installed in close proximity to flammable or
combustible materials or pressurised containers.
• Make sure that there are no electrical cables or pipes in
the wall which could be damaged during installation.
Make sure the rawl plugs and screws used to mount the heater
are suitable for the wall type onto which the appliance is going to
be installed. If in doubt, ask professional qualified personnel.
The brackets on the Glass and Mirror heaters are suitable for
wall mounting only.
The heater bracket provides the option of hanging your heater
in either landscape or portrait orientation. Rotate and fix to suit
preferred position.
The wall bracket (A) is attached to the wall on 4 corners.
This must be done at a suitable height and position with the
correct fixings for the construction of wall. See page 8 for
measurements.
The panel bracket (B), attached to the heater, can then be slid
into the wall bracket (A). The retaining grub screws can then be
tightened (C).
400w heaters - One mounting bracket
800w and above - Two mounting brackets
Wall Bracket (A)
Mating Wall & Panel Bracket (B)
Joined Brackets (C)
Mounting (Advised)
1.5m to middle of heater from
floor if wall mounted.
Mounting (Mandatory)
0.50m to any surrounding objects
0.50m to any wall or ceiling
(Minimum)
0.50m to any electrical socket
(Minimum)
Must NOT block with any items,
clothing or furniture
