Jidé s.a. – Rue des Meuneries 11 – B-4650 HERVE (Belgique) – Tél. +32 87 31.75.12 – Fax +32 87 31.75.11 –
NORDIC PLUS (EN) June 2018
10
USER NOTICE
Starting a fire
Before lighting, remove ashes by means of the pull knob (to give off the grid by leaving 2 to
3 cm of ashes in the content of the stove).
The ashtray must be emptied regularly to allow the passage of the air for combustion.
Do not exceed the maximum loading authorized (see page 15).
IMPORTANT actions before starting your fire:
1
For the correct use of the appliance, the door must be opened slightly and the grid
must be opened too (position forward) for 15 minutes - the time necessary to reach a
sufficient temperature in the fireplace.
2
When the window is hot, please close the door. Combustion air inlet is regulated by the
automatic thermostat to obtain reduced wood consumption with respect to the heat
recovered. When the fireplace is hot, fans start automatically. Ashtray can never be
opened or removed when the device is working.
We advise you to set thermostat on 9 to start the fire, and on 3 or 4 when normal use.
GRID
ASHTRAY
THERMOSTAT
DOOR
Starting the fire
Open
Close
automatic
Half-open
Hot fireplace
after 15
minutes
CLOSED
CLOSED
automatic
CLOSED
-
It is not recommended to change thermostat from maximum to minimum without any
transition.
-
For good performance do not remove completely the ashes of the stove.
-
When the fire need a reloading, open thermostat to maximum and speed controller to
minimum. Open slightly the door in order to avoid reverse flow of smokes in the room.
After loading, do not forget to position thermostat and ventilation on the desired
position (in use: 3 or 4).
-
Caution: never use without ventilation!
