User’s Manual
16
Figure 2.18 COM3/4Connector
Table 2.6: COM3/4 Serial Port Pin Assignments
Pin
Signal Name
Pin
Signal Name
1
DCD
6
DSR
2
RxD
7
RTS
3
TxD
8
CTS
4
DTR
9
RI /+5V/+12V
5
GND
10
NC
2.4.7 SATA0 (Serial ATA) Connector
1 Serial ATA 3.0 ports with data transfer rate up to 6Gb/s (SATA 0).
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Serial ATA
data cable to a SATA connector and insert the other on-board docking parallelly into another Serial ATA
device.
Figure 2.19 SATA0 Connector
Table 2.7: SATA Pin Assignments
Pin
Signal Name
Pin
Signal Name
1
GND
5
RXN
2
TXP
6
RXP
3
TXN
7
GND
4
GND
2.4.8 SATA(Serial ATA) Power Connector
2.5mm Pitch 1*4 Pin wafer Connector, One on board 5V and 12V output connectors are reserved to
provide power for SATA devices.
Figure 2.20 SATA Power Connector
Summary of Contents for ALAD-A1201T
