JFW 50MS-192, Operating Manual, Page: 7 / 11

Rev 0, 7-27-06
Page - 7
7 - Ethernet Configuration Information
This unit comes pre-programmed to the following settings:
I.P. Address 192.168.1.225
Gateway 192.168.1.1
Netmask 255.255.255.0
Port 3001 (hard-coded into the unit and can not be changed)
Important Note: An additional document “Sample Ethernet Configuration Session for JFW
Model 50MS-192.PDF” comes with this manual and is located on the CD in
PDF format. This sample session shows step by step how the Ethernet port is
configured.
Open up a terminal session through your computer’s COM port using a program like
HyperTerminal. You must use the Ethernet Configuration Cable to make the physical connection
from your COM port to the “Ethernet Config. Port” on the rear of the 50MS-192. The terminal
session should use the following COM port settings:
Baud Rate 9600
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
You can verify a successful connection by typing “Hello World” in the terminal window. You
should receive an echo back from the 50MS-192. The SET commands listed below can then be
used to change the network properties.
SET IP xxx.xxx.xxx.xxx changes the I.P address
SET NETMASK xxx.xxx.xxx.xxx changes the Netmask
SET GATEWAY xxx.xxx.xxx.xxx changes the Gateway
SET NAMESERVER xxx.xxx.xxx.xxx changes the Nameserver