17
The unloader nozzle-chute adjusts the direction of the blast and it turns 360 degrees. To
adjust the nozzle-chute, see the following instructions and figures:
TURNING THE NOZZLE-CHUTE:
move the TURNING ARM.
POINTING THE BLAST:
move the ACTUATOR.
PICK-UP:
The picking-up of the forage chopper machine must be constant, but based on the operating
capacity of the installed motor, considering the assembly characteristics of the machine and
motor. An excess intake of material will overload the motor and, if the maximum
recommended amperage is exceeded and this can cause serious damage.
The amperage verification can be done using an ammeter.
TURNING OFF THE FORAGE CHOPPER:
Before turning off the Forage Chopper machine, wait until all the products is blasted from the
machine and the machine is completely empty. Never turn off the machine when there is
product inside.
Before turning on the machine, carefully check the following:
- Check to see if there are any objects or tools on the machine, motor, or inside the pick-up
nozzle-chute.
- If there are any people or animals near the machine.
- If the machine cover if properly latched.
- If the motor rotation direction is correct.
- If the belts are properly stretched.
When the Forage Chopper machine is properly coupled and completely empty, start the
motor (turn on the tractor power take-off, in models actuated by the tractor) and wait for a few
moments, until the machine reaches the proper operating rotating speed.
Unloader nozzle-chute
Operation
Caution!
Keep the hands away from the moving roller, pulleys, gears, belts and axles.
Do not try to remove any remainders of products, straw etc., from inside the
pick-up or unloader nozzle-chutes, when the machine is turned on.
Never use the pick-up nozzle-chute without first closing the protective cover.
TECHNICAL MANUAL OF OPERATION - JF 30 EVO
TURNING ARM
TURNING ARM
BLAST DEFLECTOR
ACTUATOR
BLAST DEFLECTOR
ACTUATOR
- High Nozzle
- Low Nozzle
fig.43
fig.44
E
n
g
li
s
h
