34
↑↓→←
: Move Enter: /-/: Value F10: Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Onboard Floppy Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system
board and you wish to use it. If you install add-on FDC or the system has no floppy drive,
select Disabled in this field. The settings are: Enabled and Disabled.
Serial Port1 Address/ Serial Port2 Address
Use this item to select serial port address for serial port one.
IrDA Mode Select
This item allows BIOS to select mode for serial port 2.
The optional settings are: IrDA(1.6 ns) and IrDA (3/16 bit).
IrDA Duplex Mode/Serial Port 2 Mode
This item allows BIOS to select full or half duplex for serial port 2(IR Mode).The optional
settings are: Full Duplex; Half Duplex.
IrTX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select transmit pin in a normal condition or inverse the IRTX(IR
Mode).
IrRX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select receiver pin in normal condition or inverse the IRRX(IR
mode).
IRTX to RX Delay Select
The optional settings are: No Delay and Reception Delay.
This item allows BIOS to select IR from RX to TX 4 characters time delay for serial port2(IR
mode)
IRRX to TX Delay Select
The optional settings are: No Delay and Transmission Delay.
3-8 Power Management Setup
The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
BIOS Screen of AMD 770 + SB710 based motherboard
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Power Management Setup
Power Management Feature
Help Item
Power Management/APM Enabled
Suspend Time Out Disabled
Power Button Mode On/Off
Video Power Down Mode Suspend
Hard Disk Power Down Mode Suspend
Hard Disk Time Out (Minute) Disabled
RTC Resume Disabled
Disable/Enable
RTC to generate a wake event
↑↓→←
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Discard Changes F6:Standard Settings F7: Optimized Settings
