13
The connectors for PS/2 keyboard and PS/2 Mouse.
(4) USB Port connector: USB1, UL1
The connectors are 4-pin connector that connect USB devices to the system board.
(5) LAN Port connector: LAN (only for PM800DMS/PM880DMS/PT880DMS)
This connector is standard RJ45 connector for Network
(6) Audio Connector: AUDIO
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC.
Line-out :
Audio output to speaker
Line-in :
Audio input to sound chip
MIC :
Microphone
Connector
(7) VGA Connector (15-pin D-Sub) Connector: VGA
(Only for PM800/PM880 Serial)
VGA is the 15-pin D-Subminiature female connector for display monitor
.
(8) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
Floppy Drive Connector
Pin 1
FDD
(9) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
VGA
USB1
LINE-OUT
LINE-IN
MIC
PS/2
Mouse
PS/2
Keyboard
LAN
USB
