42
user is using) will exchange data. Both computers should have the same or
compatible settings.
Press [Enter] to make settings for the following items:
Out-of-Band Mgmt Port
The optional settings: [COM1]; [COM1(Pci Bus0, Dev0, Func0) (Disabled)].
Terminal Type
The optional settings: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
Emulation
:
[VT100]
: ASCII char set;
[VT100+]:
Extends VT100 to support color,
function keys, etc.;
[VT-UTF8]
: Uses UTF8 encoding to map Unicode chars onto 1
or more bytes;
[ANSI]
: Extended ASCII char set.
[VT-UTF8]
is the preferred terminal type for out-of-band management. The next
best choice is
[VT100+]
and then
[VT100]
.
Bits per second
Use this item to select serial port transmission speed. The speed must be matched
on the other side. Long or noisy lines may require lower speeds.
The optional settings: [9600]; [19200]; [57600]; [115200].
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a “stop” signal can be sent to stop the data flow. Once
the buffers are empty, a “start” signal can be sent to re-start the flow. Hardware
flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
