7
Hardware installation
2-1 Hardware installation Steps
Before using your computer, you had better complete the following steps:
1.
Check motherboard jumper setting
2.
Install CPU and Fan
3.
Install System Memory (DIMM)
4.
Install Expansion cards
5.
Connect IDE and Floppy cables, Front Panel /Back Panel cable
6.
Connect ATX Power cable
7.
Power-On and Load Standard Default
8.
Reboot
9.
Install Operating System
10.
Install Driver and Utility
2-2 Checking Motherboard’s Jumper Setting
(1) CPU F.S.B. Clock setting: JMP1
The motherboard’s CPU Front Side Bus clock adjusted through jumper JPM1.
This motherboard is jumper-less design. When you set JMP1 to AUTO, no jumper
or switch are needed, you can then set CPU Frequency through the BIOS setup.
BIOS Setup>Miscellaneous Control>Host clock at Next Boot is
Table as below:
CPU
(MHz) 1-2
3-4 5-6 7-8
AUTO
ON
ON
OFF
OFF
* Default
66
MHz OFF
OFF ON ON
100
MHz
OFF OFF OFF ON
133
MHz
OFF OFF OFF OFF
CPU F. S. B. Clock Setting
AUTO
1
4
JMP1
66MHz
1
4
JMP1
100MHz
1
4
JMP1
133MHz
1
4
JMP1
(2) CMOS RAM Clear (3-pin): JBAT1
A battery must be used to retain the motherboard configuration in CMOS RAM
short 1-2 pins of JBAT1 to store the CMOS data.
