Jetter JetControl 365MC, User Manual

Page: 13 / 148

Jetter AG Product Description | 3
User Manual – JetControl 365MC 13 / 148
LED Status Color Description
D1 OFF --- Normal operating condition.
Blinking at 1
Hz Red Automatic IP configuration; AutoCopy function
is completed, or first half of start delay is being
executed.
Blinking at
4 Hz Red Reset; fatal error, or second half of start delay
is being executed.
ON Red autocopy.ini file is being executed.
D2 OFF --- Boot loader is not running.
Blinking at 1
Hz Red Boot loader: Automatic IP configuration.
Blinking at
4 Hz Red Reset or fatal error.
ON Red Boot loader is being executed.
3.4.2 LED states during the boot process
If the following requirements are met, the bus nodes goes through the normal
boot process without errors:
■ Mode selector S11 is in RUN position.
■ There is a valid OS.
■ There must be a valid application program.
The LED flashing patterns indicate the different stages of the boot process.
LEDs R E D1 D2 State
Phase 1 Reset
Color Green Red Red Red Reset
Blinking
pattern 4 Hz 4 Hz 4 Hz 4 Hz
Phase 2 Operating system
Color Green - - Red The device is initializing the
operating system.
Blinking
pattern 1 Hz OFF OFF ON
Phase 3 Parser
Color Green - - - The OS reads the settings of
the DIP switch on the back-
plane module and checks
whether an Ethernet switch
exists.
Blinking
pattern 1 Hz OFF OFF OFF
Phase 4 Interfaces and programs
Color Green Red - - The OS initializes realtime
clock, Ethernet interface and
file system.
Blinking
pattern 1 Hz ON OFF OFF
Phase 5a Start delay
The controller only executes phases 5a and 5b only if a time value is entered in
R 202971 Start delay .
Color Green Red Red - The first half of the start de-
lay is in progress.
Blinking
pattern 1 Hz ON 1 Hz OFF