Jetter JC-120MC, User Manual

Page: 399 / 634

Jetter AG 399
JC-120MC Programming
JX2 system bus - Description of non-volatile registers
Non-volatile registers let you configure the JX2 system bus. Any changes to a
non-volatile register become effective only after the JC-120MC has been
relaunched.
I/O dummy modules
Each bit in this register represents an I/O module on the JX2 system bus.
Meaning of the individual bits
Bit 0
Configuration of I/O module 2
0 = I/O module is a dummy module
1 = I/O module is not a dummy module
Bit 1 Configuration of I/O module 3
0 = I/O module is a dummy module
1 = I/O module is not a dummy module
etc. Configuration of I/O module 4 ... 24
0 = I/O module is a dummy module
1 = I/O module is not a dummy module
Module register properties
Value after reset Non-volatile; factory setting: -1
Takes effect Next time when the controller is launched
Slave dummy modules
Each bit in this register represents a slave module on the JX2 system bus.
Meaning of the individual bits
Bit 0
Configuration of slave module 2
0 = Module is a slave dummy module
1 = Module is not a slave dummy module
Bit 1 Configuration of slave module 3
0 = Module is a slave dummy module
1 = Module is not a slave dummy module
etc. Configuration of slave module 4 ... 17
0 = Module is a slave dummy module
1 = Module is not a slave dummy module
Introduction
R 200002023
R 200002024