Set up:
Before you can put up the stroller, you need to open the safety inter-
lock (fig.1a) first. Pull the slider upward (fig.1b), so that the stroller
is set up completely. The stroller is set up, when a distinct latching
sound results. Then check whether all parts are firmly attached be-
fore you put your child in the stroller.
Fastening of the wheels:
For fastening the front wheels, push these onto the suspension on
the frame until they latch audibly (fig. 2a & 2b).
For detaching the front wheels, push the safety button (fig. 2c) and
pull the wheel from its suspension.
For fastening the back wheels, plug these into the receiving opening
of the suspension (fig. 3a). You can hear that the wheel is locked
when you hear a clicking sound. Control the secure halt by pulling. For
a later detachment of the rear wheels, pull the safety button upward
and pull the wheel from the suspension (fig. 3b).
Operation of the break:
For operating the break push the break lever downward with your
foot (fig.5a).
By pulling the lever upward you can loosen the break again (fig.5b).
Attention:
Always use the break when stopping with the stroller.
Adjusting the brake after a period of using the baby stroller:
In order to adjust the brake of your stroller, use a spanner to rotate
leftwards adjuster nut B, which is located on the back side of the rear
support strut of your stroller (figs. 5a & 5b). This will reduce the dis-
tance between the two nuts A & B and increase the braking force. You
can then secure screw B by turning secure nut C as far to the right as
possible.
GB
Summary of Contents for JESSE
