COMPLEX RADIO CONTROL SYSTEM
FS position
- throw setup of selected FailSafe output position in
case of signal loss
FS speed
- sets how quickly the throws move to the FailSafe
positions in case of signal loss
Pin Config
- receiver pin config can be:
Pin Config - servo
ź
standard impulse output for servos (-100% = 1ms, 0%= 1,5ms /
+100% = 2ms )
Pin Config - Digital
output
ź
the output pin is in a stable LOW condition (log. 0) if the position
of this channel is negative, otherwise this pin is in HIGH
condition (log.1)
ź
ensure that pin is used only as logical output, don't draw the
current above 1mA
Pin Config -
Digital i
nput
ź
here the pin is configured as an input and its condition
(disconnected/connected to the ground) is sent to the
transmitter as other telemetry data from the sensors
ź
it is allowed to keep the pin disconnected or connected to the
common ground of the receiver
ź
it is not allowed to connect to a different voltage. The pin works
exclusively in PullUp mode so all you need to test the function is
to connect the signal pin to the ground.
Output Group
- setup of given output into a selected group of
output pulses, which will be simultaneously generated by the
receiver.
EN
23